Will Fastecho read a HPT created JAM message base? Or will I need to somehow convert it over so that FE can use it?
I would prefer using an existing message base than starting from scratch.
On 06/12/16, Jeff Smith said the following...
Will Fastecho read a HPT created JAM message base? Or will I need to
somehow convert it over so that FE can use it?
I would assume so. A JAM msgbase is just that, wheather it was created
by HPT or FastEcho shouldn't matter.
I would prefer using an existing message base than starting from scratch.
That should be possible as long as both software are sticking to the program.
Will Fastecho read a HPT created JAM message base? Or will I need to somehow convert it over so that FE can use it?
I would prefer using an existing message base than starting from scratch.
Will Fastecho read a HPT created JAM message base? Or will I need to
somehow convert it over so that FE can use it?
I asked because I ran into that problem before where one tosser
couldn't read the JAM message base that another tosser had created.
I asked because I ran into that problem before where one tosser
couldn't read the JAM message base that another tosser had created.
one of the tossers was out of spec... can you say which ones and the versions?
i guess the rough date would also be good since there was some changes made during early development and adoption...
... Still crazy after all these years.... ;*)
Sysop: | digital man |
---|---|
Location: | Riverside County, California |
Users: | 1,103 |
Nodes: | 15 (1 / 14) |
Uptime: | 48:17:13 |
Calls: | 231,341 |
Calls today: | 7 |
Files: | 59,770 |
D/L today: |
307 files (165M bytes) |
Messages: | 295,321 |
Posted today: | 7 |